Eastman Eagle Static Cutter (S-125)

The static table system is available in a range of system lengths and widths to meet the demands for prototypes, one-offs and full production runs. The system's high-precision configuration features multi-axis motion for more defined and accurate cuts. Material is spread across the static table by an operator or with the use of a pneumatic gripper bar. This computer-controlled system features zoning capabilities to enable cutting in one area while the operator is simultaneously picking parts in another, maximizing daily production capacity.
Specifications:
​-Width: 54 in. (1.37m) 60 in. (1.54m) 72 in. (1.82m) 78 in. (1.98 m) 96 in. (2.44 m) 108 in. (2.74 m) 114 in. (2.90 m) 126 in. (3.20 m) 156 in. (3.96 m)+
-Length: 8 ft. (2.44m) 12 ft. (3.66m) 16 ft. (4.88m) 20 ft. (6.10m) 36 ft. (10.97m)+
-Drive System: Dual-X Axis, Y-Axis & Theta Axis. X & Y-Axis Rack & Pinion Drive, Brushless Servo Motors
-Electric Control Power/PC: 230V, 3 ph, 50/60 Hz, 5.4 kVA. Stand-alone step-down/up transformer required for other voltages.
-Electric Vacuum Blower:
208/230/380/460V, 3 ph, 50/60 Hz, 7.5 HP, VFD control optional
-Power: Pneumatic75 – 90 psi at 15 SCFM (5.17 – 6.2 bars at 0.42cmm)
-Maximum Cutting Speed60 inches/second (152.4cm/second)
-Maximum Acceleration1.3g
-Maximum X/Y Speed60 inches/second
-Compressed Air Consumption15 CFM
-Sound Level: <76 db(A)
-Operating Temperature: 55 – 100°F (12–37°C)
-Humidity: 20 – 80% (non-condensing)
Safety:
​-Four remote emergency stops: two on cutting gantry, two system-mounted
-Additional gantry-mounted stop disks pause system operation until returned to neutral and reset. Operation can then be resumed from any position
-Tool head is equipped with plexiglass safety window to keep hands free of knife during operation
-Single turn-off point with a universal power system for lockout/tagout safeguards employees from unexpected start-up